Laurell Technologies
Operations Manual WS-400 Lite Series
All information contained in this manual is the property of Laurell Technologies Corporation® and is NOT to be edited, reproduced or
distributed without express written permission from a corporate officer.
30
2.2.4 INDECK CONNECTIONS
Indeck installations require cabling the remote control box assembly to the spin
processor. Two cables and one vacuum sensor hose are required, which can be
detached at the rear of the remote control box, see Figure 2-3A.
Figure 2-3A
INDECK CONTROLLER – REAR VIEW
The spin processor vacuum, seal purge and remote connections are located on the
bottom of the spin processor housing (see photo below, Figure 2-3B).
Figure 2-3B
Twist-lock interconnect
cable connection from
spin module
AC Power Cord
Vacuum sense tube
from spin module
Vacuum Valve
To Controller
Motor’s Seal
Purge - N
2
/CDA
Circuit breaker / Power
switch
