LAUNCH
TLT830WA Product Manual
7
4 Installation and commissioning and Unpacking
4.1 Please get the following tools ready for installation
:
Tools Specifications
Level Bar
L=400
(
15.7
″)
Chalk Line
10mm
(
0.4
″)
Taper Plunger Chip
Hammer
1.5 kg (3 lb)
Crescent Wrench
40mm
(
1.6
″)
Open end Wrench Set
11mm-23mm
(
0.43
″
-0.9
″)
Allen Wrench Set
2mm
~
12mm
Screwdriver
150mm
(
5.9
″)
Rotary Hammer Drill
20mm
(
0.8
″)
Hard Alloy Drill Bit
Φ
19mm
(
0.75
″)
Frame Level
(
JB3239-83
)
L*W*H
=
300x40x300(11.8
″
x 0.16
″
x 11.8
″
)
4.2 Unpacking
The lift is delivered in three separate boxes: 2 platforms (with hydraulic hoses) and 1 control desk.
Unpack according to the instructions on the packages. Remove the packing materials and check for
damage and loss of components.
To avoid accidents from occurring, keep the packing material away from children. The packing materials
need to be disposed of properly if they may contaminate the environment.
5. Equipment installation
5.1 Basic requirements
y
The lift can only be installed on concrete floor with a minimal thickness of 200mm
(
7.9
″)
,
and at least
7 days of solidification time.
y
The strength of the concrete ground should exceed 3000PSI
(
2.1kgf/mm2
)
。
y
The tolerance of the concrete floor levelness should not exceed 5mm
(
0.2
″)
。
Slight slope can be
corrected with shims. Excessive slope on the ground will greatly affect the performance of the lift. In
this case, new concrete slab should be made.
y
Inspect for possible hindrance such as low ceiling, overhead pipelines in the work area, passageways
and escapes. The working area of the lift should be 4.2M
(
165.4
″)
high to give enough space.
y
Allow enough space
(
at least 2M
(
78.7
″)
)
at the front and back of the lift so that operation should not
be hindered. (see fig6)
y
Power supply: Put the power source in place before installation. All the wiring should be performed by a
qualified electrician.
5.2 Installation Procedures
5.2.1 Tunnel Installation
Tunnel positioning mode is the same as the normal positioning
,
but tunnel positioning is more difficult
than the usual ones because to avoid cars slipping, the hanging plates hidden component need to be
replaced. Tunnel size see fig 6, normally only few people install the lift without the hanging plates hidden