LAUNCH
TLT830WA Product Manual
9
car direction
32
67
.1
54
3
480
2585
1565
235
54
9
59
9
80
0
25
199
8
16
-φ
20
Master
Slave
Fig 7
Attention
：
♦
All dimensions are based on outer boundary of the base plate.
♦
Ensure that the overall error control within 6mm
（
0.24
″）
♦
Draw a layout is very important. If not, problems will arise in the final assembly and
operation
5.2.3 Control Desk Installation
z
According to the situation on the ground to determine the positions of electronic control boxes and
determine power supply requirements for local use, according to the diagram requirements
z
Wiring diagram shown in figure 8.
z
After opening the side door of electronic control box, connect the limit switch cable to terminals
（
5
，
7
）
on the big scissor, connect the limit switch cable to terminals
（
6
，
7
）
on the small scissor. Then use
4x2.5mm2 wire (Supplied by the customers themselves) respectively to connect the terminals L1, L2, L3,
PE. Check the correct connection before let the power on; open the control box to turn on the power
switch, now the power indicator light on the operator panel is on.
