Lauda VC 1200, Руководство по эксплуатации

Страница: 36 / 112

Command Meaning
RMP_START Starts programmer
RMP_PAUSE Stops programmer
RMP_CONT Starts programmer again after hold
RMP_STOP Stops the program
RMP_RESET Deletes program (all segments)
RMP_OUT_00_XXX.XX_XXX
XX_XXX.XX_X
Sets the programmer segment (temperature, time, tolerance and pump
level). A segment is added and allocated the appropriate values.
RMP_OUT_02_XXX Number of program cycles: 0 = infinite / 1–250
Please note:
n For “_” “.” (space character) is also permitted.
n Response from the thermostat “OK” or “ERR_X” in the case of
an error. RS ‑ 485 ‑ interface e.g. “A015_OK” or with error
“A015_ERR_X”.
n The command from the control centre must be terminated with
CR, CRLF or LFCR.
n The response from the constant temperature equipment is
always terminated with CRLF.
n After every command sent to the constant temperature equip-
ment, it is necessary to wait for a response before the next
command can be sent. This way, the allocation of queries and
responses is clear.
CR = Carriage Return (hex: 0D); LF = Line Feed (hex: 0A)
-XXXX.XX -XXXX.X -XXXX. -XXXX XXXX.XX XXXX.X XXXX. XXXX
-XXX.XX -XXX.X -XXX. -XXX XXX.XX XXX.X XXX. XXX
-XX.XX -XX.X -XX. -XX XX.XX XX.X XX. XX
-X.XX -X.X -X. -X X.XX X.X X. X
-.XX -.X .XX .X
4.4.7 Error messages from the constant temperature equipment to the control
centre
This list describes the error messages.
The following information refers to the Ethernet
‑
as well
as the RS 232/485 ‑ interfaces.
Permitted data formats
Before starting up
Variocool 36