lassele DY-110H, Руководство по обслуживанию

Страница: 35 / 47

35
2) INSTRUCTION FOR EACH CASE OF MALFUNCTION
(1) Not working, even when operation switch is on
①
When setting temperature is done but time setting is 0
- Adjust time setting appropriately.
②
Fuse is disconnected
-
Check the fuse.
③
Circuit breaker of main meter works.
(2) Circuit breaker of main meter frequently works and temperature of wire is high
①
Lack of capacity of circuit breaker.
②
Capacity of wire is low.
- Change the breaker and wire with the rated capacity.
- Standard of breaker and wire for each model
(3) Dehydrator properly operates but dehydration result is different for each dehydration room.
①
Gap at DOOR GASKET is widened
- Check distortion of DOOR and its closure.
②
Check partition leakage at each dehydration room.
- Seal each cabinet by applying silicon.
③
Closure
of DAMPER ASS’Y of each dehydration room is different.
- Check closure of DAMPER and adjust it at certain angle during closed.
(4) Dehydrator is properly operates but dehydration is not done because of faulty moisture discharging.
①
When dehydrator is at enclosed area
- Move and locate it to the place with good ventilation.
②
When the rear of dehydration is too close with the surface of a wall
- Secure enough space between discharging outlet and a wall for good ventilation. (At least more than 30
㎝
)
(5) Main PCB, heater, ventilation motor and wiring are at normal sate but temperature is not increasing.
①
Thermo limiter works due to internal overheating
- Reset thermo limiter.
- If it works within the setting temperature, replace it, as judged to be faulty.
Model DY-110H DY-220H DY-330H
Breaker 30A 30A 50A
Wire 2.5SQ 4SQ 6SQ
Adjust DAMPER of each
dehydration room to make its
closure uniform.
RESET BUTTON