lassele DY-110H, Руководство по обслуживанию

Страница: 34 / 47

34
Problem Cause Resolution
Warning of sensor
error is displayed
(C1/C2/C3)
It does not always mean
product have a problem and
can be shown temporarily.
a. It is due to temporary change in voltage, thus, re-operate
it by turning ON power after OFF after stabilizing it.
b. If it keeps happening, replace main PCB as it means
error at RELAY for main PCB heater.
Temperature sensor is
disconnected, short or sensor
is faulty.
a. Replace sensor after checking temperature sensor.
b. Check connection wiring line.
Heater is disconnected.
(If it blanks every dehydration)
Replace it after checking whether heater is damaged or not.
Alarm rings
Dehydration is done.
(Remaining time is 0)
Press alarm off button.
There is an error at machine.
If alarm off button is pressed, alarm is temporarily paused.
(Inspect after checking error code)
Temperature is not
increasing
Temperature is set low.
Make the setting temperature higher with setting
temperature UP/DOWN.
Moisture discharging control is
open too much.
Reduce moisture discharging appropriately.
Heater is disconnected.
Replace heater after checking there is a damage at it or
not.
Ventilation motor is damaged.
Replace ventilation motor after checking there is a damage
at it or not.
Dehydration is not
done well
Too much stuff is put into the
cabinet.
Reduce volume of stuff appropriately.
Stuff is not located evenly. Spread stuff evenly and sometimes mix it.
Moisture discharging is not
adjusted.
Adjust moisture discharging, depending on stuff.
Stuff is overdone or
burned
Dehydrating temperature is
too high.
Lower setting temperature and increase heating time more.
Stuff is not located evenly. Spread stuff evenly and sometimes mix it.