Landoll Brilllion Till'N Seed BPSB-8, Руководство оператора

Страница: 36 / 76

3-4 F-1097-2305
OPERATION
TABLE OF CONTENTS
Attaching/Detaching 3-PT Hitch
Till 'N Seed
WARNING
Hooking Up the Till 'N Seed:
1. Attach the Till 'N Seed to the tractor. Raise the
Seeder.
2. Raise Parking Stands by removing each Parking
Stand 3/4" Pin and lifting the Parking Stand until the
bottom hole is aligned with the bracket hole. Replace
the 3/4" Pin.
See Figure 3-2.
3. Remove both 3/4" Rear Roller Locking Pins from the
Frame LH and RH End Plates and place them in the
Toolbox.
See Figure 3-3.
Unhooking the Till 'N Seed:
1. Raise the Till 'N Seed. Lower Parking Stands by
removing each Parking Stand 3/4" Pin and lowering
the Parking Stand. Align one of the three holes with
the bracket hole depending upon the site ground,
replace the 3/4" Pin.
See Figure 3-2.
2. Both sides, insert 3/4" Rear Roller Locking Pins into
the Frame LH and RH End Plates to lock the Rear
Roller Arm.
See Figure 3-3.
3. Lower the Till 'N Seed and disconnect the tractor from
Seeder.
Figure 3-2: Parking Stand
Figure 3-3: Rear Roller Locking Pin Engaged
Tractor Preparation for Attaching
Pull Type Till 'N Seed
DANGER
DANGER
1. The Till 'N Seed is designed to be used with a
Category 2 Drawbar Hitch.
2. Align the Tractor Drawbar with the machine. Raise or
lower the Drawbar Hitch as needed using the Jack.
Attach the unit with proper size Hitch Pin and Safety
Clip.
See Table 3-1.
Table 3-1: Pin Size
3. Raise and rotate Jack to stored position before setting
the machine in motion.
4. Clean all hydraulic couplings and attach to the tractor.
5. Attach Safety Chain to tractor allowing plenty of
movement for turning both directions. The Safety
Chain should latch securely to prevent it coming
loose.
See “Safety Chain” on page 1-4.
6. If Transport Locks are not engaged, fully extend the
hydraulic lift cylinders and rotate Transport Locks in
the engaged position over the Cylinder Rods. Secure
with the Clevis Pins and Hair Pin Cotters.
See
Figure 3-4.
To prevent the implement from tipping forward on
the frame, disengage parking stand only when the
seeder is fully attached to the tractor. Be sure to
observe the following sequences.
Parking
Stand
Drive Rotor
Parking Stand
3/4" Pin
Frame
Do not allow any bystanders to stand between the
tractor and the implement while backing up to the
implement.
DRAWBAR CAT Min Pin Size Max PTO HP
2 1-1/4" (30mm) 154 (115 Kw)
3/4" Rear Roller
Locking Pin
Rear Roller Arm