Landoll Brilllion Till'N Seed BPSB-8, Руководство оператора

Страница: 27 / 76

ASSEMBLY
F-1097-2305 2-9
TABLE OF CONTENTS
Agitator Installation
CAUTION
IMPORTANT
Never force to add a Square Bore Washer since it will
cause binding. Agitators must be free to rotate.
Blade Agitators are standard. Blade Agitators must be
installed with careful attention to the direction of Shaft
Rotation.
See Figure 2-11.
Figure 2-11: Blade Agitator Orientation
Contact the Brillion office for rates and compatibility with
unlisted seed varieties
NOTE
Square Bore Washers are two thicknesses, 12ga and
14ga. It may be necessary to use more than one Square
Bore Washer for proper fit between the Agitator Bearings.
1. On the RH end of the Agitator Seed Box, remove the
5/16-18 Hardware that attaches the Bearing Standoff
to the RH Support.
See Figure 2-12.
2. Slide the Agitator Shaft out of the end of the Seed
Box. Bearing Standoff and Bearing should be still
attached to the end of the Agitator Shaft.
3. Remove existing Agitators and Square Bore
Washers.
4. If applicable, orient and place the Agitators inside the
Seed Box. Place Square Bore Washers on each end
of the Agitators to prevent seed leakage and to
reduce Agitator end play between the Agitator
Bearings. Never force to add a Square Bore Washer
since it will cause binding. Agitators must be free to
rotate.
5. Reinstall the Agitator Shaft aligning the Square Bore
Bushings, Square Bore Washers, and Agitators.
6. Reinstall the Bearing Standoff to the end of the Seed
Box with 5/16-18 Hardware.
Figure 2-12: Agitator Assembly
Blade Agitators orientation is important. Be sure
to determine the direction of shaft rotation before
installation.
Blade
Agitator
Pointer
Indicator
Plate
Front
Shaft
Rotation
Flange Locknut,
5/16-18
Flange Bolt,
5/16-18 x 1
Agitator Shaft
Bearing Standoff
Bearing