Landoll 2211, Руководство оператора

Страница: 19 / 74

ASSEMBLY INSTRUCTIONS
3-3
Disc Chisel Frame Assembly
IMPORTANT
Read all safety precautions at the front of the section
before attempting any of the following procedures.

WARNING
1. Place both frame halves on stands approximately 36”
high. The assembly area should be a large level area
of sufficient size to accommodate the Disc Chisel
when fully assembled.
2. Insert top casting (p/n 150167) onto shank tube
alignment point with other point under the frame
when fully assembled. Note that top and bottom
castings have p/n cast on them
(See Figure 3-1.)
NOTE
It may be necessary to loosen the screws holding the lift
on the left frame half when attaching casting to the shank
tube.
3. Align both the shank tube and rockshaft in position.
This will also line up the plate on each end of the
frame.
4. Bolt frame halves together using 3/4-10 x 2-1/4 hex
head cap screws and hex lock nuts in the front and
rear plates. Bolt frame halves together using 3/4-10 x
2-1/2 hex head cap screws and hex lock nuts in the
center cylinder mount plate. Leave all screws loose.
5. Install the 1" u-bolts over the frame and through the
top casting holding the shank tube, bottom casting
(p/n 150168) and hex lock nuts.
6. Install the 4" UHMW bearing onto the left lift.
7. Connect lift bearing cap to right frame using 3/4-10 x
2 hex head cap screws and hex lock nuts.
8. Level the frame halves.
9. Tighten all hardware to the recommended torques
shown in
Table 2-1.
Do not attempt to lift heavy parts (such as the
frame, disc gangs, wheel lift, and pull hitch)
manually. Use a hoist or a forklift to move these
parts into position.