8
A
B
Increase
Decrease
C
E
A. Flow Control, Water
B. Flow Control, Syrup
C. Nozzle (Diffuser inside)
D. Retainer Clip
E. Soda Lever
D
A
B
A. Syrup Separator
B. Soda Lever
A
B
C
A. Syrup Separator
B. Ratio Cup
C. Verify Soda/
Water Level
6. Re-open syrup shut-off at mounting block.
7. Activate valve to purge syrup until steady flow is achieved.
9. Remove syrup separator and reinstall nozzle. Replace valve
cover.
10. Repeat steps 1-8 for each valve.
11. Re-install merchandiser, splash plate, and top cover.
4. Remove nozzle by twisting counter clockwise and pulling
down, then remove diffuser by pulling down.
5. Install Lancer (yellow) syrup separator
(PN 54-0031)
in place
of nozzle.
Adjust Water Flow Rate & Syrup/Water Ratio
1. Remove merchandiser.
2. Close syrup shut-off at mounting block for first valve.
3. Using a Lancer ratio cup verify water flow rate (5 oz. in 4
sec.). Use a screwdriver to adjust if needed.
Ensure there is ice on the cold plate and the lines are
cold before attempting to set the flow rates on the
valves. The drink temperature should be no higher than
40°F (4.4°C) when flow rates are set.
NOTE
For units with flavor injector lines, it is required to
remove the merchandiser to gain access to valves.
NOTE
8. Using a Lancer ratio cup, activate the valve and capture a
sample. Verify that the syrup level is even with the water
level. Use a screwdriver to adjust if needed.
Volumetric Valve Adjustment
The Volumetric Valve is an optional valve for the
44” Sensation dispenser.
NOTE
1. Remove the ID panel from the front of the first valve.
2. Insert the programmer’s 10-pin connector into the ID panel
plug located on the front of the circuit board.
3. When properly connected, the programmer will run a self
diagnostic test. The display will show all “8’s” with the
decimal points lighted. After about three (3) seconds, the
display indicates the setting of the dip switches.
If the programmer does not run its diagnostic test
properly, disconnect it and try plugging it in again. If the
programmer still fails, replace the programmer.
NOTE
4. After the programmer is connected, Press the “Read Mem”
button.
5. Press the “Ratio +” or the “Ratio
-” key until the desired ratio is
displayed.
6. Verify the drink type by pressing
“Carb Toggle” to select “C” for
carbonated or “n” for
non-carbonated.
7. Press the “Enter” button to
program the valve with the
setting on the display.
8. Verify Ratio by pressing “Read
Mem”.
9. Disconnect the programmer and
repeat steps 4-9 for each valve.
- Handheld Programmer
Volumetric Valve
