11
DO NOT
disconnect flavor lines from nozzle, when
removing from bracket.
NOTE
Always remove the ice chute lever before removing the
splash plate.
NOTE
4. Remove or melt out any remaining ice from the ice bin.
5. Disconnect the two (2) lower, horizontal LED light bars and
remove from unit.
6. Disconnect vertical LED light bar, next to flavor injector
nozzle, from the junction box and remove from unit.
7. Repeat previous step for second light bar on opposite side of
the unit.
8. Rotate the flavor injector nozzle 90° to disconnect from
bracket.
11. Disconnect the Auger Motor wire harness from junction box.
12. Remove the four (4) screws from the bracket holding the
Auger Motor, flavor injector bracket, and LED light bracket.
13. Slide the Motor and Mounting Plate Assembly off of the
Auger Shaft.
C
A
B
A. Auger Motor
B. Auger Shaft
C. Solenoid
A
B
C
A. Auger Motor Shaft
B. “C” Clip
C. Ice Chute
9. Use a screwdriver to remove the Auger Motor shaft cover.
10. Remove the “C” clip from the Auger Motor Shaft.
14. Remove the Auger Motor Shaft Key and set aside.
15. Remove the second clip from the Auger Shaft.
16. Disconnect the Ice Chute wire harness from the junction box.
C
A
B
A. Solenoid
B. Solenoid Pin
C. Ice Chute Link
17. Disconnect the solenoid from Ice Chute link by pushing pin
through shaft until link is free. (Pin shown in out position)
A
B
C
A. Agitator Clip/Pin
B. Hub
C. Agitator Bar
22. Remove the Agitator bar and Hub from the Ice Bin.
23. Remove the plastic Ice Shroud by”pinching” in the center
and rotating out.
24. Using the Cleaning Solution (page 9) and a clean cloth or
soft brush, clean the Ice Chute Assembly, Ice Shroud, Auger,
all sides of the Ice Bin, and surface of the aluminum casting.
25. Using the Cleaning Solution and the sponge brush provided,
clean all interior surfaces of the ice chute and the ice chute
feed through.
26. Using hot water, thoroughly rinse away the cleaning solution.
27. Wearing sanitary gloves, use a clean cloth or towel and the
Sanitizing Solution (page 9) to wash all surfaces of remov-
able parts, sides of the Ice Bin, and surface of the aluminum
casting.
28. Using the Sanitizing Solution and the sponge brush
provided, clean all interior surfaces of the ice chute and the
ice chute feed through.
29. Wearing sanitary gloves, reassemble all removable parts.
Ensure agitator clip is locked.
30. Fill unit with ice and replace Top Cover.
31. Reconnect Dispenser to power source.
18. Remove the Ice Chute Assembly by removing four (4)
screws that secure to unit and set aside.
19. Remove Auger by pulling straight out from unit and set aside.
20. Repeat Steps 5 - 14 for second Auger Motor Assembly.
21. Remove Agitator Clip and Pin from Agitator bar in Ice Bin.
