5
Dispenser Installation
The installation, and relocation if necessary, must
be carried out by qualified personnel with up-to-date
knowledge and practical experience, in accordance with
current regulations.
NOTE
1. Remove the cup rest, drip tray, and top cover from the unit.
2. Twist/Rotate the ADA panel, located on the unit’s splash
plate, in a counterclockwise direction up to a 45° angle.
7. Connect tubing to water source then flush water lines to
check for leaks.
8. If necessary, install water booster (Lancer PN MC-163172)
between water supply and the unit.
9. Using tubing cutters, cut plain water line and install U-fitting
then route appropriate tubing from the U-fitting to the
carbonated water inlet at the unit.
A
B
A. Oetiker Pliers
B. Tubing
C. Syrup/Water Inlet
C
If a separate water line is run for plain water, ensure
that it also has a shut-off valve.
NOTE
4. Disconnect ADA harness and remove from the unit. Repeat
Steps 2-4 for second ADA panel.
5. Remove the unit’s splash plate and merchandiser.
6. Route appropriate tubing from the water source to the plain
water inlet at the front of the unit and connect tubing to inlet
using the oetiker pliers and fittings,(see Plumbing Diagrams
on the front of the unit or on page 12 for reference).
B
A
A. ADA Panel
B. Splash Plate
10. Cut carbonated water line and install remote pump deck per
manufacturer’s specifications.
A
B
C
A. Line to Water Source
B. U-Fitting
C. Carb Water Line
D. Plain Water Line
D
6. Guide the edges of the merchandiser up, to the outside of
the side brackets of the unit.
7. Hook the top of the merchandiser to the manual fill ice chute.
It is recommended to remove the front ice bin lid before
installation.
8. Verify that the connection tabs are locked in the openings on
the sides of the merchandiser.
Merchandiser needs to be installed over the valve
plates for proper installation.
NOTE
CORRECT
INCORRECT
3. Carefully pull ADA panel and electric wire harness from the
unit’s splash plate, until the harness connector is visible.
A
A. Remote Pump Deck
B. Pump Inlet
C. Pump Outlet
D. Line to Unit
B
C
D
11. Complete the carbonated water line connection between the
remote pump deck and carbonated water inlet at unit.
12. Install a shut-off valve in the water line feeding the deck.