lancer CENTURION II 85-0056, Инструкция по установке и обслуживанию

Страница: 8 / 40

E. To set unit that has not been factory preset for a product, adjust
o
Brix and change product plate
on control panel.
F. In some locations, the water supply pressure may be so low or may fluctuate so much that a
25 PSIG (1.76 kg/cm
2
) flowing water pressure cannot be maintained. As a result, the unit will
not dispense a product at the proper
o
Brix. In this event, the regulated water pressure should
be reduced below the local inlet water supply pressure so that a proper
o
Brix can be maintained.
Reducing the regulated water pressure will reduce the finished product flow rate. Normally, the
minimum recommended setting is 15 PSIG (1.06 kg/cm
2
) flowing. To reset regulator, refer to
Section 6.13.K-Q.
G. Readjust
o
Brix as necessary.
H. Slide control panel into control housing and tighten screws finger tight. Be sure control panel is
properly seated in control housing.
1.11 CONCENTRATE LOW LEVEL INDICATOR
A. The unit is equipped with a concentrate low level indicator system.
B. Beeper (dispensing only). At low level, the beeper will emit sound only while a drink is being
dispensed.
1.12 PRODUCT PLATES
Install the proper product plates in the holes on the front panel to indicate the product being served.
2. OPERATING UNIT
2.1 REFILLING CONCENTRATE CONTAINERS
A. Remove top cover.
B. Place opened can of
COMPLETELY THAWED concentrate into concentrate container.
C. When the concentrate low level indicator is sounding, the concentrate container can be refilled
with the following quantity.
Concentrate Container Number of 42 Ounce Cans Number of 96 Ounce Cans
Small 2 1
Large 4 2
2.2 CHANGING PRODUCT
A. Flush unit until only water is dispensed from spout (refer to Section 1.9.B-C).
B. Remove lid on top of unit.
C. Remove the concentrate container and nozzle from the unit and clean with warm soapy water,
rinsing thoroughly. Fill with completely thawed concentrate and replace in unit.
D. Replace lid and nozzle.
E. Depress dispensing paddle with cup until a steady flow of pre-mixed product is obtained. Unit
is now ready to dispense. Install nozzles and check
o
Brix.
F. Change product plate on front cover to indicate new product.
NOTE
If the new product requires a different mixing ratio, refer to Section 1.10, Brixing.
2.3 CLEANING AND SANITIZING INSTRUCTIONS
A. Daily
1. Press and hold the FLUSH switch and simultaneously activate each dispensing paddle until
clear water dispenses from each nozzle.
2. Remove and wash drip tray and cup rest.
3. Wipe dispenser with clean damp cloth.
B. Weekly
1. Turn off water supply to the dispenser.
2. Press the flush position on each dispensing station to drain water from dispenser.
3. Remove lid and wash thoroughly.
4. Remove check valve (yellow elbow) from concentrate container by lifting up.
4