lancer CENTURION II 85-0056, Инструкция по установке и обслуживанию

Страница: 11 / 40

WARNING
IF UNIT IS TO BE TRANSPORTED OR STORED WHEN AMBIENT TEMPERATURE IS 32
o
F
(0
o
C) OR LOWER, STEPS C AND D MUST BE PERFORMED TO PREVENT THE WATER
SYSTEM FROM FREEZING AND DAMAGING UNIT. DO NOT USE CO
2
GAS TO PURGE WATER
FROM UNIT AS IT WILL CAUSE A HEALTH HAZARD.
E. Turn key switch OFF.
F. Unplug unit power cord from electrical outlet.
G. Remove agitator deck and using plastic tubing, siphon water out of ice bath compartment. It will
be necessary to pour about 6 ounces (177.4 ml) of warm water ( do NOT use extremely hot
water ) into the retainer that holds the ice bank control sensing bulb. This defrosts the ice around
the retainer allowing the agitator deck to be removed. Replace agitator deck and secure with
nuts.
H. Remove drip tray and cup rest. Clean and replace. Wipe unit exterior surfaces with a clean
damp cloth.
4.2 TRANSPORTING UNIT
The best method of handling and transporting a unit is to remove legs and secure unit to a plywood
shipping base. If it is to be handled and transported with the legs assembled to the unit, special care
should be taken not to damage unit.
DO NOT LAY UNIT ON SIDE OR BACK.
4.3 SHIPPING UNIT
If a unit is to be shipped by a common carrier, it must be secured to the plywood shipping base and
repacked in the original carton with the inner packaging material. For this reason, it is wise to retain
the original packing material.
5. PERIODIC MAINTENANCE
5.1 LUBRICATION
All motors are lubricated for life and require no maintenance lubrication.
5.2 CLEANING WATER STRAINER
A. Remove splash plate.
B. Close inlet water shut off valve.
C. Remove plug from strainer on regulator assembly and remove strainer screen.
D. Clean strainer screen with water. Inspect for holes or other deterioration.
E. Replace cleaned or new strainer screen. Do
NOT over tighten strainer plug.
F. Open inlet water shut off valve.
G. Replace splash plate.
5.3 CLEANING INLET AIR FILTER
A. Remove splash plate.
B. Remove inlet air filter by removing spring retainers.
C. Clean air filter with water.
D. Replace air filter and spring retainer.
E. Replace splash plate.
5.4 CLEANING CONDENSER
A. Unplug unit power cord from electrical outlet.
B. Remove splash plate.
C. Remove fan guards (lower and upper).
D. Remove condenser fan motor.
E. Clean condenser with a small brush.
F. Replace condenser fan motor, fan guards and splash plate.
G. Plug unit power cord into electrical outlet.
5.5 CLEANING CONCENTRATE CONTAINER COMPARTMENT
Use only warm water and damp cloth. DO NOT USE ANY POWDER OR ABRASIVE CLEANING
COMPOUNDS THAT WILL DAMAGE FINISH.
7