Lance Design TDC-100B, Предварительное руководство по установке и эксплуатации

Страница: 27 / 28

27
The GPI/RS232 connector is identical to the older TDC-100s, and provides GPI input
and output connections. Note that to use the GPIs they must be enabled in the TDC
menu.
The outputs may be active high or active low, as selected in the menu.
The RS-232 port is available to upload and download cues using the Cueman or
MAC Cueman applicatons. The RS-232 data format is 9600 baud, No Parity, 8 Data
bits and 1 stop bit. (9600/8/N/1).
GPI / RS-232
Pin # Function
1 Ground
2 RS-232 RX (to TDC100)
3 RS-232 TX (from TDC100)
4 GPI In 2
5 GPI In 4
6 GPI Out 1
7 GPI Out 3
8 GPI Out 5
9 Ground
10 Ground
11 GPI In 1
12 GPI In 3
13 GPI In 5
14 GPI Out 2
15 GPI Out 4
A suitable cable to connect to the user’s PC or Mac may be wired as follows. Almost
any wire may be used. Standard shielded audio pair (Belden 9451) works fine.
RS232 INTERFACE CABLE (FOR PC UPLOAD/DOWNLOAD OF CUES)
TDC-100B
RS232/GPI
PC COM PORT
DB-15 MALE DB-9 FEMALE
PIN 1 SIGNAL GROUND PIN 5
PIN 2 DATA FROM PC TO TDC-100B PIN 3
PIN 3 DATA FROM TDC-100B TO PC PIN 2