Lamtec BT300 BurnerTronic, Руководство пользователя

Страница: 136 / 254

135
6 Operating Control and Displays
NOTICE
In ’Setting mode’ these two device functions are available for curve view:

Store point

Delete curve set
NOTICE
Take the following information from this window:

A blue frame around curve and around channels’ position information indicates channel
selection for setting.

Fields ’Setpoint’ show setpoint position of the actuator.

Fields ’Actual Value’ show actual position of the actuator.

’Big’ diagram shows curve progression of the selected channel.

Yellow point with red border shows the position of selected point.
4. Change the actuator position (folding square) at the selected curve point with the
buttons and .
5. Select another curve point with the buttons and .
NOTICE
These functions are not limited to the button fields of window ’Curves fuel/air ratio’. Also use
arrow keys on your keyboard.
6. Select ignition point of ’internal firing rate’ 2 with button .
Display of internal firing rate in diagram window or in display field ’internal firing rate’ (be-
side ’EI-Mode’ button) shows the values which have changed.
7. Click with cursor in the small diagram ’Channel 1’.
The data field of channel 1 gets a blue frame. Channel 1 is selected.
8. Set actuator’s position for ignition position with the buttons and .
9. Click on the button ’save point’ to confirm.
The point is stored.
As soon as the point has been stored the program reads data again from BT300.
10. Select stage 1 (firing rate point 200) with button .
11. Adjust coarse (approximate) position of the actuator for level 1.
12. Repeat process for stage 2 (firing rate point 300).
13. If ready at hand: Repeat the process for stage 3 (firing rate point 400).
The stages are coarsely adjusted.
Fig. 6-49 Values are reloaded