Laguna Tools Robland X31, Руководство владельца/по сборке

Страница: 30 / 48

25) CUT-OFF/MITER FENCE - The cut-off/Miter fence provides a back rest for the workpiece being
cut and supports the swivel-length stop and the cutting scale. It makes possible the ability to make
precise angular and length cuts repetitively.
Two fences are available through Laguna Tools: 48" and 24". See accessories.
26) SLIDING TABLE - The sliding table is roller-bearing mounted on a set of rails which run parallel
to the saw blade. The table is free to move along the side of the saw table, allowing the operator to
move the work piece with precision, in a line which is parallel to the saw blade. In addition, the work
piece can also be moved past the shaper head while being held rigidly on the table.
27) SHAPER WORK HOLD-DOWN ASSEMBLY - This is mounted on the shaper guard housing with
adjustable fixtures with which the pushers are adjusted to push the work piece down onto the table
and in towards the guide fence. They work to make it unnecessary for the hands to be in the area of
the cutter; and as you will see, they assure a smoother cut.
28) RAIL SUPPORT ADJUSTING BOLT, OUTBOARD - This bolt is used to fasten the rail support to
the front or rear panel of the machine. The location of the rail assembly can be adjusted by loosen-
ing the bolts.
29) RAIL SUPPORT ADJUSTING BOLT, INBOARD - This bolt is used to fasten the rail support to
the front or rear panel of the machine. The location of the rail assembly can be adjusted by loosen-
ing the bolts.
30) RAIL ASSEMBLY - The rail assembly supports the sliding table assembly. It is adjustably mount-
ed on the left side of the machine adjacent to the saw table. The extended rear end of the rail is
supported by the rail support leg (not illustrated).
31) RAIL SUPPORT - The rail support is an extruded aluminum bracket devised to support the rail
assembly.
32) LOCKING BLOCK - The locking block is a rectangular steel block with a threaded hole at its
center. It is designed to lock the rail assembly to the rail support in conjunction with the sliding table
rail-locking lever.
33) LOCKING GROOVE - The locking groove is a groove located in the center of the under side of
the rail assembly. The locking block runs in this groove and grips it to lock the rail assembly in place.
34) HAND HOLE - This is a blank plastic square which is insert provided to allow access to the inner
workings of the machine through the front panel.
35) CLAMP POST - The clamp post acts as a pivot point for the cut-off/miter fence and the wood
clamp. Both the fence and the clamp can be used simultaneously.
36) COTTER KEY - This is used in the ends of the rail assembly to retain the sliding table on the
rails.
37) LARGE KNOB LOCKING SCREW - These are screws with large hand knobs cast for heads and
are used at various points on the machine where frequent locking and unlocking occur and hand
tightening will suffice.
38) MITER PIVOT BRACKET - The miter pivot bracket is an aluminum-extruded part which locks to
slide the cut off/miter fence and pivots on the clamp post.
28.