Laguna Tools Robland X31, Руководство владельца/по сборке

Страница: 33 / 48

*The switch box can then be moved in and to the right to remove it from the left side panel.
*Remove bolts (fig. C2, items C3 & C4) and the corresponding bolts at the rear of the machine. The
left side panel of the machine will come away from the machine.
*Replace the switch panel on the box so that you do not damage any of the equipment in the main
switch box. At this point your machine should appear as shown in fig. C3.
*If your doorway is thirty-six (36) inches, you can now move the machine through by moving the rear
of the machine near the opening and putting the main switch box through first, being careful not to
stretch the wires.
*Then move the machine through the door. If you prefer, move the front of the machine through the
opening first and bring the main switch box through last, again being careful with the wires.
(Fig. C2)
If the machine is still too large for the doorway, go on to the next step which is the removal of the
jointer infeed and outfeed tables.
WARNING!
Safety first. Do the following steps with your safety in mind.
YOU WILL NEED SOMEONE TO HELP HOLD THE JOINTER TABLE WHILE REMOVING IT.
Loosen the jointer lock levers; then remove the black jointer height-adjustment knob.
Using a brass punch or wooden dowel, hit the hinge pin out in a downward motion carefully while
supporting the outside edge of the table so it does not fall.
Once the pin is removed, set the jointer table to one side and remove the other.
WARNING!
Don't remove the hinge bolts or it will change your jointer table alignment!
C4
Fig. C2
Fig. C3
31.