Laguna Tools Robland X31, Руководство владельца/по сборке

Страница: 27 / 48

7) COMBINATION SAW DEPTH ADJUSTMENT & LOCK - Depth adjustment is made by releasing
the lock mechanism (rotate the handle counter-clockwise); then push the handle down to increase
the saw exposure above the table or pull the handle up to decrease the saw exposure.
The lock must be securely set (rotate the handle clockwise) prior to the saw operation.
Warning
Always check the blade clearance before startup.
8) PLANER FEED ROLL DISENGAGE LEVER - This lever is used to engage and disengage the
planer feed roll.
DISENGAGE by moving the lever to the left to clear the detent and then down.
ENGAGE by pressing lever to the left and up past the detent.
9) PLANER THICKNESS-SETTING LOCKING LEVER - This lever is located immediately behind the
planer thickness-setting crank and is used to prevent the thickness setting from changing while the
planer is in operation.
To lock the thickness setting, move the lever in the clockwise direction. To unlock, move the lever in
the counter-clockwise direction.
10) PLANER THICKNESS-SETTING CRANK - The thickness setting crank decreases the
thickness of the work piece when turned in the clockwise direction and conversely increases the
thickness when turned in the counter-clockwise direction. One (1) complete turn of the crank will
change the thickness by approximately 4mm (.160 inches).
11) JOINTER KNIFE GUARD (shown out of position) - This guard is used to cover that portion of
the jointer cutter which is not being used to join the work piece. The guard is either moved to the
side or lifted up to allow the work piece to contact the cutter.
Warning
USE THE GUARD - Remember the cutter is very sharp and is turning at 5500 RPM whether
your fingers are in it or not! YOU CANNOT BE TOO CAREFUL AROUND THIS TOOL.
12) JOINTER TABLE-LOCKING LEVER - Rotate the lever and pull it toward you to release the joint-
er table so that it may be hinged away to clear the area for the use of the thickness planer. Note that
both sides of the jointer table are locked in the same manner. To lock the table, push in on the lever
and rotate it firmly into the lock position. In addition it should be noted that the locking levers are a
cam type locking mechanism and can be locked by turning the lever in either direction. You must,
however, unlock the lever by turning it in the opposite direction as it was turned when locked. For
convenience, it is suggested that you lock it by turning it in the counter-clockwise direction. The
jointer tables need to be locked only when the machine is being moved.
13) SAW RIP FENCE - The saw rip fence gage sets the work piece at the distance you wish to
the right-hand side of the saw blade.
The saw rip fence can be adjusted from a position which is completely on the table to a position
which is completely off the table and any position in between. This function is very useful in front of
and behind the leading edge of the blade. It is helpful to withdraw the fence to the off-table position
before removing the assembly from the saw. This allows the assembly to be removed from or
25.