Laguna Tools MSANWB25X60-1K-7.5-0197, Руководство пользователя

Страница: 16 / 62

16
Connecting the air supply
The input air regulator regulates the air pressure
that is supplied to the machine.
The machine is supplied with an air connector, to
which you can connect your air supply. You will
require an air supply that can deliver a constant
minimum pressure of 6 bar. The machine is
supplied with an input air regulator that you will
need to adjust to 5.5 bar once you have connected
your air supply to the machine.
Note. No air pipe is supplied, as the length will
depend on your installation.
To adjust the air pressure, pull the cap up and
rotate until the gauge reads the correct pressure.
Once the pressure is adjusted, push the cap in.
Note. An air supply of 6 bar minimum is required
for the machine.
It is strongly recommended that 7 bar be supplied
to the machine and that the regulator then be set to
5.5 bar. This will ensure that the machine always
has the minimum required air pressure. The input
regulator has a moisture trap that must be empted
each day. To drain the moisture, pull down the
nipple at the bottom of the moisture trap.
Note. It is important that the air supplied to the
machine be clean and dry. The machine will not
perform consistently if the air is dirty, as any dirt will
block the valves. Wet or damp air will damage your
machine and cause inconsistent performance.
Note. The pneumatic system does not need any
type of lubricant. Some types of lubricant can
damage the machine and compromise the
machine’s functions.
Note. During maintenance, always disconnect the
air supply.
Air line connection
Air pressure adjuster
Moisture trap nipple