Laguna Tools MSANWB25X60-1K-7.5-0197, Руководство пользователя

Страница: 34 / 62

34
Burn marks on the job. Sanding belt is too fine
for the job. Replace the sanding belt
with coarser grit sanding
belt.
Sanding belt clogged. Clean belt with belt
cleaning stick or replace
the sanding belt.
Deep sanding marks or
grooves in job. Sanding belt too coarse. Replace sanding belt with
finer grit.
Clogged sanding belt. Clean or replace sanding
belt.
Job has rounded start
and/or finish edges. Excessive depth of cut. Reduce depth of cut.
Sanded job not parallel. Table not parallel to
sanding head. Adjust the table to
sanding head.
Job dented or scratched. Dirty pressure rollers. Clean pressure rollers.
Job has glazed marks or
scratches snaking along
the job. Glazed sanding belt. Clean or replace sanding
belt.
Poor sanding results. Worn sanding belt. Replace sanding belt.
Clogged sanding belt. Clean sanding belt and
check dust extraction for
blockages.
Sander will not start. No power supplied to
machine. Check that the electrical
power cord is plugged
into the power outlet.
Check that the electrical
supply is on (reset the
breaker).
With the power
disconnected from the
machine, check that the
wiring to the plug is
correct. Check that the
rubber insulation is
stripped enough and is
not causing a bad
connection. Check that
all the screws are tight.
Check the supply voltage
is correct.