Laguna Tools MSANWB25X60-1K-7.5-0197, Руководство пользователя

Страница: 19 / 62

19
Starting the sander
1.
Connect the sander to the power.
2. Press the table up and down keys. The table should move smoothly.
Note. Check that the table moves in the correct direction according to the arrow that is
being pressed. If the table moves in the incorrect direction, you will probably have the
input electrical wiring wrong and will need to change phase wires (3-phase machine
only).
3. Press the conveyor start and stop buttons. The conveyor should start, run and stop
smoothly.
4. Press the sanding belt start and stop buttons. The sanding belt should start, run and
stop smoothly.
5. Let the sander run for a few minutes and listen for unusual noises or vibration. If any
unusual noises or excessive vibration is detected, correct the problem before sanding a
job.
There are two main functions to adjust on the sander: the bed of the sander and the
sanding belt.
Vertical adjustment of the bed
The bed is adjusted both manually and electronically.
Manual vertical bed adjustment
The manual handle is located on the front of the machine
under the bed. This handle is not recommended for
everyday operations and should only be used for
emergency operations, or when the bed has to be moved
while no power is connected to the machine.
Manual bed adjusting
handle
Adjusting the Sander