Laguna Tools MCNC SS2 4X8 6 HP LIQUID COOLED, Руководство пользователя

Страница: 13 / 51

13
Assembly & Setup
Cleaning the Machine
The machine is shipped with the non-painted surfaces protected from rust by
a film of grease. The grease must be removed with WD40 or similar solvent,
as it attracts sawdust and dirt. The surfaces should then be coated with a
Teflon lubricant or similar. Teflon tends to dry and will not attract sawdust and
dirt.
Fitting the Dust Hose
Fit the dust shroud to the two air cylinder rods and clamp in position with the
clamping nuts.
1) Fit a 4-inch dust hose (not supplied) to the dust shroud and secure with
the clamp. Ensure that the clamp is tight.
2) The head of the machine will move across the complete table, and the
dust hose will follow the head. If there is insufficient slack, the hose may
break or damage the dust shroud. It is suggested that the hose be
suspended from the ceiling of the shop with sufficient slack so that it will
not restrict movement. This will also keep the hose from becoming a trip
hazard.