Laguna Tools MCNC Creator Pro I-24P, Руководство пользователя

Страница: 31 / 66

MCNC Creator Pro I-24P
31
a. Previously stored Breakpoints can be overwritten.
b. Use the X+/- buttons to scroll through the list.
c. Use the OK button to select the desired location.
Before resuming from a Breakpoint, a HOME operation needs to have been performed if the
machine was just restarted.
3. When ready to resume working from the stored Breakpoint, press RUN/PAUSE + (1-8)
together. The saved location number (1-8) should be the number used.
a. The controller will display the same Save Break locations seen before.
b. Use the X+/- buttons to highlight the desired file and press OK to select.
c. The current g-code position for that break will be displayed. The g-code lines can be
scrolled through at this point and break resumed anywhere in the list.
d. If that G-Code position is acceptable, press OK.
e. The display will have moved on to the file parameters that appear before all file
operations. Once these are approved the file will begin at the saved location.
4.12 Power Failures
During an accidental power failure, a soft version of a Breakpoint is set where the current
parameters and coordinates are automatically saved by the system. This information will become
available to resume at the next immediate start of the machine.
The information is not saved permanently, thus if it is not resumed at the next start of the
machine, the information will be lost.
When power is returned to the machine, perform a HOME operation. Afterwards the Want to
Restore prompt will be displayed.
Press OK to restart the unfinished file operation.
CAUTION
If the operation is canceled, the ability to resume from the
saved location will be permanently lost.