Laguna Tools MCNC Creator Pro I-24P, Руководство пользователя

Страница: 25 / 66

MCNC Creator Pro I-24P
25
e. When all axes have been set, press OK a final time to approve the movement.
Once the movement has been approved, all three (3) axes will move simultaneously to
the specified locations. Be mindful of fixtures and any hold-downs that may become
obstructions during movement.
4.5 Setting Work Origin
Creating an Origin will establish a zero point or
reference point from which the machine will perform
the cutting process set in the toolpath.
The Origin should match the zero point (datum) of the
uploaded toolpath created in the design software.
An Origin for both the X and Y axes and the Z-Axis
need to be set before beginning operation of a file.
Failure to set both the Origins may result in damage to
the machine or the cutting tool.
To set the Origin:
1. Verify the tooling is properly secured within the
collet. Use only ER-20 collets of the correct size
matching the shaft diameter of the selecting
tooling. The machine ships with ¼” and ½” collets
(standard sizes for imperial router bits).
2. Move the spindle or router to the desired location
using the X and Y directional buttons.
a. Remember that the controller can be switched between movements speeds using the
FSP and LSP settings. Step mode or grid movements can be used to place the bit more
accurately for the Origin placement.
b. This location is typically one of the corners of the work material or the exact center point.
3. Press XY-0 to set the Origin for the X and Y axes. This will instantly change the displayed
coordinates of the X and Y axes to 0.00.
4. There are several ways to set the Z-0 or Z-Axis Origin, which may change depending on the
material or router bit that is being used.
a. Using the provided tool touch-off device (plugs into the female connector on rear of
HOME side gantry).
Figure 4-3: Spindle Head