Laguna Tools MCNC Creator Pro I-24P, Руководство пользователя

Страница: 28 / 66

MCNC Creator Pro I-24P
28
In the Menu + 1 area (coordinate state #2), the Origin would be set for the second piece of
material.
The materials can be loaded onto the machine, preferably using a fixture for ease of referencing.
The first job can be performed from the #1 state. Then the controller can be switched to the #2
state and the second piece of material can be machine.
4.7 Setting Spindle RPM
The Creator Pro machine is equipped with a Delta
VFD-m invertor for spindle RPM control. This can be
found on the front of the white control box.
To adjust the RPM, simply turn the dial. Clockwise
(right) to increase RPM and counterclockwise (left) to
decrease RPM.
This can be adjusted at any time. Included during a
machine operation. Allowing RPM to be dialed
dynamically as needed.
The display shows the RPM in 60Hz frequency. This means that while the RPM is 0-24,000, the
display will show 0-400. Each 100-displayed is equal to 6000 RPM.
The buttons on the VFD are intended to be used for programming only and should not be used to
set the spindle speeds.
4.8 Processing a file
Once the Origin is placed (all axes) and the RPM is set, the file can be selected and machining
can begin.
To ease the use of a USB flash drive (U-Disk), once files are saved to the U-Disk always select to
Eject the drive to safely remove it from the computer. This will help ensure that the controller will
recognize the U-Disk when it is inserted.
To begin (from the coordinate screen):
1. Press the RUN/PAUSE/DELETE button.
2. Select either the U-Disk or internal memory recently used file (must be one current U-disk or
a in memory):
Figure 4-6: Adjust the RPM