Laguna Tools MCNC Creator Pro I-24P, Руководство пользователя

Страница: 30 / 66

MCNC Creator Pro I-24P
30
2. During toolpath operation – While the file is in operation, the Y+/- buttons can be used to
increase or decrease the Speed Scale in 0.1 (10%) increments. Cannot exceed 1.0 (100%) of
the feed-rate programmed in the software.
4.10 Pausing During Toolpath Operation
A file that is in operation, otherwise known as a job, can be paused. While paused, some
changes can be enacted. This function should only be used for very brief pauses to adjust
settings, such as a bit height or position.
To pause a job:
1. Press the RUN/PAUSE button during operation.
a. The machine movement will immediately stop.
b. Spindle remains active.
2. While the machine is Paused, the bit position can be adjusted in any direction. It is
recommended that this be done in Step mode and in Low speed (LSP).
3. After making the adjustments, press RUN/PAUSE to continue the file operation. The display
will show a Restore Position? prompt.
a. Press OK to resume using the modified settings.
b. Press Cancel to resume using the previous settings.
Be advised, changes that are made will only affect the toolpath in operation.
4.11 Setting a Breakpoint
Like the Pause button function, a Breakpoint or Stop can also be used. In this case, the
Breakpoint operation can be used for extended periods including saving the location and
returning to finish a job even days later after restarting the machine.
To create a Breakpoint:
1. Press the STOP/CANCEL button during an operation.
a. Pressing a 2 nd time will cancel the Save Break function and the position will be lost.
b. When the Save Break prompt appears, press OK.
2. The display will show the available locations (1-8).