Laguna Tools MCNC Creator Pro I-24P, Руководство пользователя

Страница: 17 / 66

MCNC Creator Pro I-24P
17
1. Insert the control box into the front right cavity of
the toolbox or for a stand without a toolbox sit the
control box on the shelf. Power and
communication cables will run through the lower
hole in the back of the toolbox.
2. Insert the cable connectors into their
corresponding female receptacles and twist the
collar to tighten. The receptacles are keyed so the
plugs will only insert one way. Inserting the bottom
cable first is recommended.
3. Verify the position of the electrical cord through
the back of the stand safely, so it will not be run
over by the castors and to prevent tripping
hazards.
4. Attach the metal end of the controller cable to the front of the control box.
a. Connect the handheld controller securely to the opposite cable end. Be careful not to
overtighten the screws.
b. When complete the controller can be hung on the hook found on the righthand side of the
stand.
5. Locate and install the stepper motor to the top of
the Z-Axis motor seat, on the gantry tower.
a. Secure the ground wire to the corner of the
stepper motor with one (1) of the four (4)
provided cap-screws. Secure the motor
electrical connector to the gantry tower and
use the three (3) remaining cap-screws on the
motor seat to secure the stepper motor.
b. Tighten the two (2) set screws in coupling that
attaches stepper motor shaft to the ball-screw.
c. Install the plastic cover stepper motor mount
and tighten the two (2) screws.
Figure 2-5: HHC on Hook
Figure 2-6: Gantry