Setting Up Your LaCie AIT Drive
page 10
LaCie d2 U&I AIT Drive
3. Setting Up Your LaCie U&I AIT Drive
Installation Steps
1. Connect the power supply
2. Install application software
3. Install the required drivers
4. Connect the LaCie AIT U&I drive via the FireWire or USB 2.0 port
5. Insure that the drive is recognized by the application software
Connecting the Power Supply
Warning! Mac Users!
Power on your computer and make sure that the OS has fully booted before you connect
your LaCie AIT U&I via USB and turn on the drive.
To operate the drive, you must use the AC adapter supplied with it.
Warning!
Use only the AC adapter supplied with your LaCie drive. Using any other power cable may cause
damage to the device and void your warranty.
Important Note:
You may use your LaCie drive when in a foreign country, thanks to its autoswitching
100-240 Volt power supply. To be able to use this feature, you may need to purchase an appropriate adapter
or cord. Consult LaCie Technical Support for assistance in choosing the right adapter. LaCie accepts no responsi-
bility for any damage to the drive resulting from the use of an inappropriate adapter. Using an adapter other
than one authorized by LaCie will void your warranty.
Connecting the AC Adapter to the Drive
1) Insert the round, four-pin metallic plug of the AC cable into the power input located at the rear of the drive.
2) Connect the wall-side plug to a power socket. Your drive should now turn on automatically when you connect it to a
USB/FireWire port on your computer.
Disconnecting the AC Adapter From the Drive
If you have inserted a tape into the drive, you must first eject the tape before disconnecting the power supply.
1) Turn the drive off.
2) Hold the drive steady with one hand, then remove the plug from the connector.
Warning!
Always remove the AC adapter before transporting your LaCie drive. Failure to remove the adapter
may result in damage to your drive and will void your warranty.
