9
selector will prompt the user to type the password to gain access to the program change.
TECHNICAL AREA
As mentioned above, through the T-NFC you can operate the door, adjust its functions and its
potentiometers, and manage its maintenance.
You can also customise the selector settings.
In order to access the technical area you need to know the 10-digit technical password for the door
(which cannot be disabled). The A B C D buttons allow to encode the password.
Important!
The technical password is required to ensure that no unauthorised, unqualified people
can change any operating parameters, which could result in serious injuries to people. It is
important and essential that the installer change the standard password to better protect the
automatic door settings
.
Hold the
SET
button pressed for about 2 seconds to enter the technical area.
The display will prompt you to type the technical password:
Type the password; if the code is correct the selector shall enter the technical area and select the first
of the 7 menus. To switch between the menus, press the B button multiple times; to enter the menu,
press the A button.
The following are the 7 menus available in the technical area:
1-SET UP
This menu allows to set up all the parameters (FULL), or to only set up the door sliding stroke (PART),
leaving all other parameters unchanged.
When you enter this menu the following message will be displayed:
Press the A button to launch a stroke setup (PART), or press B to launch a full setup (FULL).
