Labconco 44000 Series, Руководство пользователя

Страница: 52 / 107

Chapter 2: Prerequisites
Chapter 4: Using Your Washer
P#o%&ct Se#+ice -./00.122.341/ 48
Washers built for use on 230V have the capability to wash
glassware at a temperature of 180[F P82[CQ. They also are
able to operate at the lower temperature of 140[F P60[CQ
which is the standard temperature of the 115V models.
Selecting a high-heat operation is achieved by selecting an
appropriate program.
On 230V models, the 5lass Plus, Scientific, and User 2 Set
programs operate at the higher temperature. When one of
these programs is selected, the display window indicates
the program chosen, as well as the term, jHI HEAT.k
When the Rinse Only, Plastic, 5lass, or User 1 Set
program is selected, the display window indicates the
program chosen, as well as the term, jLOW HEAT.k
USE CARE WHEN SELECTIN5 HI5H-
HEAT PRO5RAMS IF PLASTIC WARE
IS BEIN5 WASHED.
To start a wash cycle:
1. Close the washer door and energize the electronic
control by sliding the door latch knob from the left to
the right position to lock the latch.
2. Press the Select Program button until the desired
program is shown on the display. To observe the
details of the program, press the Shift Prog button.
The display will then show the Wash 1 time, the Wash
2 time, the number of rinses, the total wash time, and
the drying time.
3. If you need to alter the Wash 2 time, the number of
rinses, or the drying time, press the appropriate button
directly below the displayed parameter until the
desired information is displayed.
4. If a pure water rinse is needed, press the corresponding
button. If the purified water is feeding from a non-
pressurized system, make certain there is adequate
water in the reservoir Pa minimum of 5 gallons or 18.9
litersQ.
☞