13. Water level control of boiler
The machine is fitted with a series of automatic level control
devices to keep the water in the boiler at a pre-set level.
The indicator light (
11
) comes on when water enters the
boiler.
Filling the boiler with water using the manual service tap
This function should be used only if the electronic level control
devices are not working correctly.
Pull out the filling lever (
5
) and press it down, taking care not to
exceed the MAX. level on the boiler water level indicator (
13
).
14. How to access the programming function
To enter the programming mode, press push button (
20
)
and keep it pressed for a few seconds; the buzzer sounds
intermittently.
To exit the programming mode, after programming the various
drinks, press push button (
20
) again for less than 1 second.
15. Programming the coffee measures
“ Before programming the coffee dispensing push
buttons fill the filter holder with the correct serving
of ground coffee. Don’t use coffee grouts for pro-
gramming servings. ”
Fit and tighten the filter holder (
10
) on the coffee dispenser
unit, positioning the cup (or cups) under the nozzle (or nozzles)
of the filter holder (
10
).
Press (and keep momentarily pressed) the coffee dispensing
push button (
16, 17, 18
or
19
) corresponding to the required
serving to be programmed.
When the amount of coffee in the cup reaches the required
level, release the coffee dispensing push button.
Repeat the above operations for the other coffee push
buttons.
16. Programming the hot water measures
Position a suitable container for the amount to be programmed
under the hot water pipe (
8
).
Press (and keep momentarily pressed) the hot water dispensing
push button (
9a
or
9b
).
When the amount of water in the container reaches the required
level, release the push button (
9a
or
9b
).
11
5
13
16
17 20 18 19
9a 9b 9c
8
32
English