Kyocera Mita KM-4530, Руководство по обслуживанию

Страница: 376 / 384

2BC/D-1
2-4-18
Maintenance
Section
part/location
Method Maintenance cycle Points and cautions Page
Optical section Slit glass Clean Every service Clean with alcohol and then
a dry cloth.
Contact glass Clean Every service Clean with alcohol and then
a dry cloth.
Mirror 1 Clean Every service Clean with alcohol and then
a dry cloth.
Mirror 2 and mirror 3 Clean Every service Clean with alcohol and then
a dry cloth.
Lens Clean Every service Clean with a dry cloth.
Reflector Clean Every service Clean with a dry cloth.
Exposure lamp Check and replace Every service Replace if an image problem 1-6-21
occurs or after the exposure
lamp has been lit for 1,000 hours.
Optical rail Grease Every service Check noise and shifting and
then apply scanner rail grease
PG671.
Original size detection Clean Every service Clean with alcohol or a dry cloth.
sensor
Maintenance
Section
part/location
Method Maintenance cycle Points and cautions Page
Developing Developing unit Replace Every service 1-6-44
section Lower developing Clean Every service Vacuum.
cover
Developing unit Clean Every service Vacuum or clean with a dry cloth. 1-6-46
upper seal Check and replace Replace if deformation, waviness
or break of the seal is found.
Seals and sponges Clean Every service Check for vacuum and breakage.
Gears Check Every service Check noise and the levels of
wear.
Grease Every service Apply grease TMP1-200G.
Developing duct Clean Every service Vacuum.
Developing duct filter Replace Every service 1-6-47
Sub hopper coupling Check and Grease Every service Check noise and Apply grease
TMP1-200G.
Maintenance
Section
part/location
Method Maintenance cycle Points and cautions Page
Image formation Drum Replace Every service 1-6-42
section Main charger unit Clean Every service Clean the shield with a wet cloth 1-6-39
and then a dry cloth.
Charger wire cleaning Replace Every service 1-6-41
pad
Grid wire cleaning pad Replace Every service 1-6-41
Charger wire Replace Every service 1-6-39
Main charger grid Clean or replace Every service Clean the shield with a wet cloth 1-6-39
and then a dry cloth. Replace if
damage or folds are serious.
Cleaning lamp Clean Every service Clean with a dry cloth.
Pre-cleaning lamp Clean Every service Clean with a dry cloth.
2-4-16