Kyocera Mita KM-4530, Руководство по обслуживанию

Страница: 229 / 384

2BC/D
1-6-25
(2-2) Refitting the scanner wires
Caution
When fitting the scanner wires, be sure to use those specified below.
Machine front: 2AC12170
Machine rear: 2AC12420 (black)
Refitting requires the following tool: Frame securing tool (P/N: 2AC68230)
Procedure
• At the machine rear
1. Insert the two frame securing tools into the
positioning holes at the front and rear of the
scanner unit to pin the mirror 2 frame in
position.
2. Secure the two frame securing tools at the
machine front and rear using the two screws
for each.
3. Hook the round terminal on one end of the
scanner wire onto the left catch on the inside
of the scanner unit. .................................
1
4. Loop the scanner wire around the rear groove
in the scanner wire pulley on the mirror 2
frame, winding from below to above. .......
2
5. Loop the scanner wire around the groove in
the scanner wire pulley at the machine right,
winding from above to below. ..................
3
6. Wind the scanner wire around the scanner
wire drum four turns from the rear toward the
hole in the drum.
7. Insert the locating ball on the scanner wire
into the hole in the scanner wire drum.
8. Wind the scanner wire a further five turns
from the locating ball toward the machine
front.
9. Loop the scanner wire around the groove in
the scanner wire pulley at the machine left,
winding from below to above. ..................
4
10. Loop the scanner wire around the front
groove in the scanner wire pulley on the
mirror 2 frame, winding from below to above.
.................................................................
5
11. Run the scanner wire around the wire guide
at the machine left. ..................................
6
12. Hook the round terminal onto the scanner
wire spring. ..............................................
7
13. Hook the other end of the scanner wire spring
onto the catch at the machine left.
14. Repeat steps 2 to 13 for the scanner wire at
the machine front.
15. Remove the two screws from each of the
frame securing tools and then the tools.
16. Move the scanner from side to side to
correctly locate the wire in position.
Figure 1-6-47
Figure 1-6-48
Scanner wire
Locating ball
Rear
Front
4 turns
5 turns
Rear groove
Scanner wire spring
Wire guide
Front groove
Scanner
wire drum
Catch
Scanner
wire pulley
Round
terminal
Round terminal
(Machine left)
(Machine right)