This document is the property of KYMATI GmbH and must not be copied or disclosed without its written authorisation.
- KYMATI GmbH – 2021
KY.MAN.0164 (2.0)
KY-RAY 3D.03.01 User Manual
Doc.- No.: KY.MAN.0164
Version:
2.0
Date:
16.06.2021
Page:
17 of 36
Figure 6: KY-RAY 3D.03.01 Mechanical Drawing (Left Side View)
Figure 7: KY-RAY 3D.03.01 Mechanical Drawing (Bottom View)
4.2
Mounting
The KY-RAY 3D.03.01 has 4 x M6x13 bolts (at the rear) for mounting purpose. Use only
stainless steel M6 DIN 985 nuts plus 6,4 mm washer according to:
1.4301 / AISI 304 / V2A (X5CrNi18/10) or
1.4571 / AISI 316 / V4A (X6CrNiMoTi17-12-2)
to mount the bracket.
For safety reasons only self-securing stainless-steel
nuts with a strength value of 12.9 shall be used.
The device can be mounted in any position. There should be nothing in the proximity of the
sensor that blocks the air convection (see Figure 8). It is recommended to install the KY-RAY
3D.03.01 with the original KYMATI bracket (KY-XTRA M.01.01 – more information can be
found under
www.kymati.com
).
