U
actual
size
2-1/8"
54 mm
1-1/2"
38 mm
K
Status LED will indicate
success or failure.
Success:
LED flashes green
Failure:
LED remains solid red
2 / 4
U
(2x)
What is the diameter of the hole in the door?
Remove battery cover and battery pack from interior assembly.
Install 4 AA batteries in battery pack.
Install interior assembly onto mounting plate.
Make sure the door is open, and
insert the battery pack.
After a few seconds, the latch bolt will retract and extend on
its own to learn the orientation of the door. This is called the
door handing process
, and it is crucial to lock operation.
If the latch bolt does not move on its own, or if the Status LED indicates
a door handing failure, make sure the cables are connected, the
batteries are installed correctly, and attempt this procedure again.
If the door handing process is still unsuccessful after a second
attempt, perform the “Manual Door Handing” procedure on page 4.
Locate screws for step 3C and keep them within reach.
Install exterior keypad and mounting plate.
A
A
A
B
B
C
D
B
C
Diameter is 2-1/8"
(54 mm)
Diameter is 1-1/2"
(38 mm)
or
“D” is required for installation.
Install “D” on “F”.
“D” is not needed for
installation. Discard “D”.
Cable goes
underneath latch.
Support exterior
assembly during
mounting plate
installation.
Route cable through
center hole, then push
cable into bottom hole.
Insert key and
test latch. If latch
does not extend or
retract smoothly,
adjust screws (T).
Remove key when
finished and make
sure the latch bolt
is fully extended.
Keep parallel to
edge of door.
Tighten
screws evenly.
a
a
c
c
b
b
d
d
Make sure turnpiece is in
the vertical position.
Note: Latch
bolt will only
retract half way.
Make sure
turnpiece shaft is
rotated as shown.
Ensure correct polarity.
For best results, use
new, non-rechargeable
Alkaline batteries only.
Do not install
batteries
until step 5.
Ensure tight cable
connection.
Lay excess cable flat inside the
bottom of the interior housing.
align
L
a
c
b
d
actual
size
T
bottom
hole
D
D
F
F
G
T
T
(2x)
T
E
M
L
L
L
K
3
Install the exterior keypad
4
Install the interior assembly
5
Install the batteries and perform the door handing process
This step will teach your lock the orientation of your door and is crucial to lock operation.
