© 2016 Spectrum Brands, Inc.
1. Association Groups
The lock supports 2 association groups. Per Z-Wave Plus requirements, group 1 is
assigned to the Lifeline group and can only support 1 node.
The Lifeline group supports the following unsolicited messages:
Command Class
Command
Command Class Battery
Battery Report
Command Class Door Lock
Door Lock Operation Report
Command Class Notification
Notification Report
Command Class Device Reset Locally
Device Reset Locally Notification
Association group 2 is identified as the “Doorlock notify report” group. It allows at
most 5 other nodes to be associated with the lock and will provide all Notification
Reports, via the Command Class Notification, generated by the lock.
2. Configuration Parameters
The Z-Wave door lock module supports the use of the configuration command class to
provide advanced configuration of the door lock over the Z-Wave network. This section
describes the configuration parameters supported by the door lock.
2.1 Configuration Parameters 33 and 34
Parameter Name: SKU (length = 8 bytes)
Data Length: 4 bytes (each parameter)
Default Values for 33 and 34: 0x20, 0x20, 0x20, 0x20 (all spaces)
Possible Values: All printable characters will be accepted
Description:
The configuration parameters 33 and 34 are used to set and get the SKU part numbers.
The SKU is made up of 8 bytes. Each parameter consists of four bytes of data.
Parameter 33 contains the first four most significant bytes of the SKU, while parameter
34 contains the four least significant bytes of the SKU.
When setting the SKU, it must be done in two set commands, one for each parameter.
The order of programming the SKU does not matter.
