Kverneland Vicon RV 2160, Руководство по эксплуатации

Страница: 94 / 263

94
Use at the field
Driving
Run 540 rpm during use
It is vital to let the machine run at 540 rpm speed during use. Only then
a fluent operation of the various functions can be guaranteed.
Please take care of the following during use:
•
the pto must be switched on
•
drive at the correct working speed (between 4 and 15 km/h); adapt-
ed according to the crop
Pto
The pto may only be switched on at low motor rpm.
> Switch on the pto
Driving speed
Use an adequate forward speed to ensure the crop is fed uniformly
and constantly into the machine.
> Adjust the driving speed according to
•
crop amount
•
windrow volume
•
ground conditions
Driving pattern
The bale shape indication arrows on the control box display indicate
how the bale is formed inside the bale chamber.
> Steer the machine in such a way that the windrow is fed alternat-
ingly at both sides into the pick-up
This in order to fill the bale chamber to the optimum.
> Continue checking this on the display
The driving is especially critical when working in a narrow windrow.
T
IP
Do not weave over a narrow windrow but always stay driving for a
while at the sides as the figure shows. This since zig-zagging causes
bad lateral feed and thus badly formed bales.
> Start slowly straight on the windrow
> Maintain 540 rpm at windrow end so eventually a binding cycle op-
erates
Driving pattern