Kverneland Vicon RV 2160, Руководство по эксплуатации

Страница: 218 / 263

218
Maintenance
Belt exchange
> Open the tailgate fully
> Fit the stop pins into the lateral wall on both sides of the bale cham-
ber.
> Lower the tailgate pressureless
The tension arm will rest on the stop bolt and slacken the belts.
> Do not lower the tailgate too far: the bale chamber must stay ac-
cessible
> Close the tailgate safety valve
> Remove the belt(s)
> Install the new belt(s) paying attention to the direction of running
when visible
For this reason the leading edge of a belt has trimmed off corners.
> Unlock the tailgate safety
> Fully the open tailgate
> Remove the spring clip
> Remove the stop pin of the side wall
> Place back the stop pin in its holder
> Place the spring clip
> Close the tailgate
> Check the belt alignment
> Correct as necessary
Renewing /exchang-
ing of a lacing
For renewing the belt lacings the following tools and parts are neces-
sary
→
Spare parts manual
Never shorten a belt more than 10 cm with respect to the original
length.
The difference in length between two used belts of one machine shall
not exceed 5 cm.
> Cut the belts square as close as possible to the lacing
RK
RL
Holder Spring clip
Stop pin
Direction of
rotation
Belts