Kverneland Vicon RV 2160, Руководство по эксплуатации

Страница: 212 / 263

212
Maintenance
Twine knife arm
The twine knife arm can be synchronized. When the twine tubes are
in the rest position, the plate must be against the frame. If not, this can
be adjusted by placing the lever into another hole.
> Remove the bolt
> Place the lever into another hole
The plate must now be against the frame.
> Mount the bolt
Twine brake - twine
boxes
Do not use the twine brake on the twine boxes to increase twine ten-
sion. This twine brake just serves to prevent the twine from unneces-
sary rolling off the spools during transport and work.
It is possible to adjust the twine brake according to the twine used (di-
ameter, different brands and quality).
Adjust as follows:
> Loosen the nuts to increase the spring length
> Tighten the nuts to decrease the spring length
The spring must just stay under minimum pressure.
Twine brake - twine
tubes
Basic adjustment of the spring length N of the twine brakes: 20 mm.
It is possible to adjust this length according to the twine used (diame-
ter, different brands and quality).
Adjust as follows:
> Check spring length N is 20 mm
> Loosen the nuts to increase the spring length
> Tighten the nuts to decrease the spring length
T
IP
Do not divert too far from the basic setting. The spring is quite stiff and
thus you easily reach a too high or too low tension.
Plate
Bolt Lever
Nuts
Twine brake
N
Nut