Kval 994-X, Руководство по эксплуатации

Страница: 101 / 130

About the Six/Eight Shooter System
4-19
KVAL 994-X Operation Manual
About the Six/Eight Shooter Controls
These controls also apply to the Eight Shooter.
FIGURE 4-28.
Identify Controls on the Six/Eight Shooter
Clear Screws:
If screws get jammed in the
six shooter, press to clear
the line. Pull away from the
machine and press the but
-
ton cause air blasts in the
line.
Reset:
Reset raises the Shooter,
putting all the cylinders back
in the Start position.
NOTE: If the tilt cylinder is
set to retract too fast, it can
cause the Six Shooter to
jump out of the pocket and
bounce on the top rail.
Insert Screw:
When the Shooter is in the
pocket position and the
operator has inserted a
hinge into the screw
receiver block hinge holder
you are ready to insert
screws.
Load / Unload:
If equipped with quick dump
hopper (OPT. Z), this button
would be used to operate this
option.
Unclamp:
Allows the operator a choice
to release the door either from
a foot pedal or a Shooter
mounted mushroom button.
Start Sequence:
The start sequence drops the
Six-Shooter into the pocket
while starting motor for
hydraulics. It also drops the
screws down, aided with air
injection, to speed the screw
feed process
Hopper Slide Valve:
The hopper slide valve provides the operator a remote air shut-off that controls air flow to the screw
hopper to aid in un-jamming debris in the screw drop zone.
Safety Insert Screw Slide Valve:
The insert screw slide valve provides the operator a remote air shut-off to prevent the Shooter head
from moving in when performing maintenance on the screw driver assembly. It is also a good practice
to shut the slide valve OFF when not in use.
Screw Driver in Close Trap
This allows the Shooter to hold the Apex bits close to the screw receiver tubes. This prevents the
screws from bouncing out during the screw application. It is also helpful when replacing bits or doing
maintenance on 3-degree bevel front section. simply plunge the head and flip the trap out of position.
This will allow the head to retract to the back position.