Kval 990FX, Руководство по эксплуатации

Страница: 60 / 96

Machine Component Terms
KVAL 990-FX Operation Manual
3-2
Machine Component Terms
This table includes definitions of common terms.
Machine Terminology
Machine
Electrical
Panels
Electrical Panels contain the brains and power for the machine. The Main
Electrical Panel contains the main PLC and servo drives. The High Fre
-
quency Panels contain the VFD’s to drive routers, width adjust, and feed
motors.
Door Clamp
The door clamp secures the door for stable routing and drilling.
Jamb Clamp The jamb clamp secures the jamb to hold it in place as routing and drilling.
Door Stop
The door stop sets the door in the correct position for processing.
Jamb Stop The jamb stop sets s reference for the jamb to be in the correct position for
processing. It is located on the front section of the machine and is set man
-
ually by the operator.
Tools
Routers Routers are located int he Carriage Heads and on the Back Section. The
routers rout the hinge pockets and rout face plates. Typically Carriage
Heads contain two routers that cut in the opposite directions to create a
smooth cut.
Bolt Drill The bolt drill is located on the back section. Drills a bolt hole on the lock
edge of the door.
Lock Bore The lock bore is located on the back section. Drills a lock hole on the face
of the door.
Pre-drills The pre-drills are located in the Carriage Heads. They pre-drill screw holes
for hinge screw application on the door and the jamb.
Chisels (opt) Chisels are located in the Carriage Heads and the back section. The chis
-
els square the corners on the hinge pockets and the lock plate.
Chip-Out
Block
Chip-Out Blocks are located under some drills to reduce tear-out on the
edges of the cut.
Operation
Operator’s
Station
The Operator’s Station is the interface of operator and machine. It contains
power controls and touch screen interface to controls the cutting parame
-
ters of the door.
Machine Con
-
trol
Located mid machine, manually set Feed (Auto-Man), LH or RH door, Start
and Stop machine.
Door Clamp
Pedal
The Door Clamp Pedal is a foot pedal that activates the Door Clamp to
either clamp or unclamp the door.
Jamb Clamp
Pedal
The Jamb Clamp Pedal is a foot pedal that activates the Jamb Clamp to
either clamp or unclamp the jamb.
Six-Shooter The Six-Shooter is located at the left side of the machine.Six Shooters
apply hinges and the secures them with screws. (3x3 pattern)
Eight-Shooter
(Opt K)
The Eight -Shooter is located at the left side of the machine.Eight Shooters
apply hinges and the secures them with screws. (4X4pattern)