Kuppersbusch EKI 6130, Руководство по обслуживанию

Страница: 12 / 25

12 Service Manual
For internal use only
5. If the process has been done correctly the decimal dot of zone 2 blinks for a few seconds, and the
message “C O” is then showed on displays cooking zones 2 and 3. The system uses always
displays cooking zones 2 and 3 to show information. These two zones are present in USIF with
three and four zones.
6. To cancel the test mode press the ON/STAND-BY button. Leaving the test mode the buzzer will
beep once (standard beep) and the appliance will go into STAND-BY mode.
Hobs with software version “2.XX” in USIF do not include the configuration menu.
9.2 Main menu
Once the right test sequence is introduced the USIF will enter the main menu providing the following
options:
Configuration
Checking - To show these two letters the USIF will use the cooking zone displays 2 and 3.
Information
If the test mode is active a timeout will be present (60 sec) when no key is touched. If this timeout elapses
without touching any key a beep signalize TEST MODE is finished and the appliance will go to STAND-
BY mode.
Configuration mode (CO)
Checking mode (CH)
Information mode (IF)
9.2.1 Swapping between modes
To switch from one mode to another is possible by using (-) / (+) keys of the cooking zone 2.
• Pressing (+) key it will be possible to shift between:
CO -> press (+) key => CH -> press (+) key => IF
• Pressing (-) key it will be possible to shift between:
IF -> press (-) key => CH -> press (-) key => CO