9. - Optional equipment
FC244/D/-FF/D-FF
89
KN329CGB_A
Mower conditioner
- Remove the 4 V-belts (1).
- Remove bolts (2).
- Exchange pulleys.
Handle pulleys with care.
Pulleys must slide on the hubs without effort.
If this is not the case, clean and slightly coat
hubs with grease before sliding the pulleys in
place.
- Reinstall the 8 bolts (2) without tightening them.
- Reinstall belts on pulleys.
- Reinstall belt tensioning bolt and washer on its
support.
- Tighten belt tensioning bolt using box spanner until
the spring is completely compressed.
- Tighten pulley bolts using box spanner:
• Torque: 12 daN m (89 lbf ft).
- Reinstall the belt guard.
- Check that the guard is engaged inside the rigid
beld guard.
- Tighten the self-locking nuts using box spanner.
- Pivot guardrail tube.
- Tighten self-locking nut of pivoting guardrail using
box spanner:
• Torque: 8.5 daN m (63 lbf ft).
1
2
2
Refer to the pictorial applied on the machine to
check the pulley position with regards to the rotor
speed.
If the leaves are damaged and the stalks
crushed, reduce the rotor speed.
888 min
615 min
-1
-1
