Kubota ZG123S-AU, Руководство оператора

Страница: 77 / 85

ADJUSTMENT 62
B
LEVEL MOWER DECK (Front-to-Rear)
To avoid personal injury:
A
Park the machine on a firm and level surface.
A Engage the parking brake.
A
Disengage PTO.
A
Stop the engine and remove the key while
checking or adjusting the level of the mower
deck.
A Check the machine tire pressure.
Inflate tires to the correct pressure.
(See "TIRES AND WHEELS" section.)
C
Checking level (Front-to-Rear)
A
Mower deck anti-scalp rollers should not contact the
ground.
1. Raise the mower deck to the transport position. (Also
the top end).
2. Turn the cutting height set dial to the 3 in. (76 mm)
cutting height position.
3. Lower the mower deck.
4. Position the right mower blade in the Front-to-Rear
position.
5. Measure from the right front blade tip to the level
surface with a short ruler or leveling gauge.
6. Turn the blade 180 and measure from right rear blade
tip to the level surface.
7. Check that the left side blade has the same dimension.
The difference between both measurements should
be less than 6 mm.
Front side must be lower than rear side.
8. If the Front-to-Rear adjustment is not within the given
tolerance, adjustment is necessary.
C Adjusting level (Front-to-Rear)
1. Raise up the mower deck to the transport position.
(Also the top end).
2. Turn the cutting height set dial to the 3 in. (76 mm)
cutting height position.
3. Place 51 mm height wood blocks under each side of
the mower deck.
Anti-scalp rollers must not rest on the wood block.
4. Lower the mower deck.
5. Loosen the jam nuts of the front side of the machine.
6. Adjust the cutting height fine tuning bolts to set 76 mm
blade height.
Both front side bolts must be adjusted.
7. Jam the nuts.
8. Adjust the other side equally.
A
The difference between both measurements should
be less than 6 mm.
Front side must be lower than rear side.
9. Check the front-to-rear level and if it is not level,
adjustment is necessary.
(A) Front
(B) Rear
Front-to-Rear
adjustment
Less than 6 mm
Front side must be lower
than Rear side.
(1) Cutting height fine tuning bolt
(2) Jam nut