_
23
_
WARNING
POTENTIAL HAZARD
・
Muffler surface becomes hot when Trimmer/Brushcutter is in operation and remains hot for
sometime after the engine is shut off.
WHAT CAN HAPPEN
・
Contact with hot muffler surface could cause a burn
.
HOW TO AVOID THE HAZARD
・
Make sure the muffler is cool before inspecting and cleaning the spark arrester
.
Maintenance Interval
•The spark arrester should be inspected and cleaned after every 25 hours of operation.
Replace the screen if it cannot be thoroughly cleaned or if it is damage.
Spark Arrester Maintenance
1. Remove the cylinder cover. (See section “Cylinder Cooling Fins”)
2. Remove the two socket head screws holding the spark arrester
assembly to the muffler.
3. Remove and clean the spark arrester assembly with a safety
solvent and a stiff brush. If any part cannot be thoroughly
cleaned, if must be replaced.
4. Reinstall the spark arrester assembly onto the muffler, then
reinstall and tighten the two socket head screws.
5. Reinstall the cylinder cover.
Spark Arrester
Gearcase
Maintenance Interval
The gearcase should be checked for lubrication after each 30
hours of use.
Gearcase Lubrication
Remove the cutting attachment and the boss adapter. Clean
any dirt and debris from the area between the boss adapter and
the gearcase. Remove the grease plug from the side of the
gearcase. While rotating the attaching shaft, inject lithium-base
bearing lube
(
P/N 211337
)
through the plug hole until the
gearcase is full. Reinstall the boss adapter and grease plug.
Spark Arrester
Muffler Body
Tail
Screw(2)
Bearing Lube
(P/N.211337)
Grease Plug
Attaching Shaft
Boss Adapter
Plug Hole
Gearcase
Содержание KBC26-RS
Страница 27: ......