_
5
_
Assembly
Assembling Engine and Drive Shaft Assembly
Attach the clutch drum housing to the engine using the four
screws supplied with the unit.
Loop Handle Installation
Loop handle must be assembled gearcase side from the arrow (A).
1. Place the loop handle and the bottom clamp on the shaft assembly.
2. Install the four screws and nuts. Tighten the screws evenly.
Horn Handle Installation
IMPORTANT: Be careful not to damage the throttle
cable and stop switch wires when you
remove the horn handles from the carton.
1. Loosen the four screws on the top of the clamp bracket.
2. Insert the left and right horn handles into the clamp
bracket.
Note that the horn handle with the throttle trigger and
stop switch goes on the right-hand side of the Trimmer/
Brushcutter.
3. Adjust the horn handles to the desired position, then
tighten the four screws.
Engine
Clutch Drum Housing
Screw
(
4
)
A
Bottom Clamp
Throttle Trigger and Stop Switch
Horn Handle
Screw (4)
Clamp Bracket
Stop Switch Wires
and Throttle Cable
Nut (4)
Loop Handle
Screw
(
4
)
Shaft Assembly
Содержание KBC26-RS
Страница 27: ......