_
14
_
Idle Speed Adjustment
This Trimmer/Brushcutter is equipped with non-adjustable fuel mixture carburetor.
The idle speed is the only adjustment for the operator.
The cutting attachment may be moving during idle speed
adjustment. Wear the recommended personal protective
equipment and observe all safety instructions.
Keep hands and body away from the attached tool.
When the throttle trigger is released, the engine should return to
an idle speed. The correct speed is 2700 - 3300 min
-1
(or just
below the clutch engagement speed).
The attached tool must not move and the engine should not stall
(stop running) at engine idle speed.
To adjust the engine idle speed, rotate the idle speed adjustment
screw on the carburetor.
・
Turn the idle speed screw in
(
clockwise
)
to increase the engine idle speed.
・
Turn the screw out
(
counter-clockwise
)
to decrease the engine idle speed.
If idle speed adjustment is necessary, and after adjustment the cutting attachment
rotates or the engine stalls, stop using the Trimmer/Brushcutter immediately!
Contact your local authorized KUBOTA Dealer for assistance and servicing.
WARNING
POTENTIAL HAZARD
・
Engine must be running to make carburetor adjustments.
・
When engine is running, attached tool and other parts are moving.
WHAT CAN HAPPEN
・
Contact with moving attached tool or other moving parts could cause serious personal injury or
death.
HOW TO AVOID THE HAZARD
・
Keep hands, feet and clothing away from attached tool and other moving parts.
・
Keep all bystanders and pets away from unit while making carburetor adjustments.
Hot Restart
To start the engine that is already warmed up
(
hot restart
)
.
1. Pump the primer bulb until fuel can be seen flowing through the fuel return line to the fuel tank. Flowing
fuel should be almost clear, not foamy or full of bubbles.
2. Turn the choke lever to the Open
“ ”
position, and set the stop switch to the “START” (ON) position.
3. Leave the throttle trigger in the idle position and pull the starter grip.
4. If the engine fails to start after three to four pulls, follow the instructions in the Cold Starting Procedure
section above.
If the engine fails to start after you follow the above procedures, contact an authorized KUBOTA dealer.
To Stop the Engine
1. Release the throttle trigger.
2. Slide the stop switch to “STOP” (OFF) position.
Idle Speed
Adjustment Screw
Содержание KBC26-RS
Страница 27: ......