KTR-STOP
®
M-xxx B-xx-xx
Operating/Assembly instructions
KTR-N
Sheet:
Edition:
445102 EN
9 of 22
3
Please observe protection
note ISO 16016.
Drawn:
2020-03-25 Shg/Wie
Replacing:
KTR-N dated 2019-08-26
Verified:
2020-03-25 Shg
Replaced by:
If you want to use brake pads after having assembled the brake, it is necessary to disas-
semble the pad holder (component 1.14 and 1.15) for that purpose (chapter 5.1).
•
Mount the pad retraction sets (component assembly 2) by screwing the screw (component 2.1) with the pres-
sure spring (component 2.2) into the brake pad.
•
Hand-tighten the screw.
•
Insert the protective plug (component 2.3).
Secure the screw connection (component 2.1) on the brake pad additionally against working
loose, e. g. conglutinating with Loctite (average strength).
•
Insert the first half of the brake (component 1) in the cor-
rect position towards the connection plate or stand,
respectively (see illustration 6).
•
Insert one of the six connection screws into the brake
until the face of the connection screw is flush with the
rear connection plate respectively stand.
Illustration 6
You should preferably insert the connec-
tion screw marked with 1 in illustration 6.
•
Insert the second half of the brake in the correct position
towards the connection plate or stand, respectively.
•
Push the connection screw screwed in before through the
second half of the brake and align it symmetrically.
•
Fasten the connection screw at the tightening torques
specified in table 4.
•
Repeat this process until the total of 6 connection screws
have been mounted.
To facilitate the assembly it is possible to fix
the position of the brake by one connection
screw only first. Swing in the brake until the
balance of the screws can be assembled, too
(see illustration 6).
Table 4: Tightening torques of the connection screws
Screw size
Tightening torque T
A
[Nm]
– 10.9
untreated and oiled
Tightening torque T
A
[Nm]
– 10.9
greased with MoS
2
M20
592
438
M24
1017
754
M27
1496
1100
In order to avoid any contact between the brake disk and the brake resulting from thermal
expansion, the distance of the brake according to table 3 needs to be observed.
!
Please make sure that the tolerances of the brake disk do not exceed the figures specified
in illustration 2.
4
Assembly
4.4 Assembly of the brake
