Desired function
Procedure
Acknowledgement signal
Arming the alarm
• Switch off the ignition
1 x optical and acoustic
Alarm signal via the siren, flasher
• The system will arm itself after 5 minutes or LED will blink (frequency approx. 2Hz)
lights and radio alarm signal (accessory)
Press button 1 once
• Press button 1 once
Switching on the silent alarm
• Switch off the ignition
1 x optical and acoustic
The alarm is only given via the
• Press button 1 twice in succession
and
radio alarm signal (accessory)
Note: by repeatedly pressing button 1 you 1 x optical
will alternate between the "loud“ and
"silent“ alarm mode
LED will blink (frequency approx. 2Hz)
Disarming the alarm
• Press button 2 once or
if no alarm is triggered:
• Press button 2 longer than two seconds
2 x optical and acoustic
to suppress the acoustic signal
if an alarm was triggered:
4 x optical and acoustic
LED will no longer blink
Switching on the hazard warning light
• Switch on the ignition
Warning hazard lights will blink
• Simultaneously press buttons 1 and 2
Switching off the hazard warning light
• Press button 1 once
Switching on the panic alarm
• Switch off the ignition
optical and acoustic
• Simultaneously press buttons 1 and 2
for approx. 60 seconds
Switching off the panic alarm
• Press button 1 once
Switching on the sleep function
• Switch on the ignition
1x optical and acoustic
• Press button 2 and hold for at least
two seconds
Switching off the sleep function
• Switch on the ignition
2 x optical and acoustic
• Press button 2 and hold for at least
two seconds
ENGLISH
Remote control
The alarm system can only be operated by means of the remote control
included in the scope of supply. The battery (type A23) needs to be repla-
ced if the light output of the LED display becomes weak or the reach of the
radio signal becomes smaller. Do not expose the remote control to extreme
heat or moisture.
Note on installation
It is recommended to have the KTM alarm system installed by a KTM
motorcycle workshop.
7
Operation of the alarm system
